I put an automated volume climb on a track. It works pretty good. I t shows on the edit screen if you go to the edit screen soit must have saved it ok. What happens if I go to the same edit area and edit reverb?? Is it going to show a second line there for the reverb ??? Will it be a different color line than the volume climb edit? I want to be able to see clearly whats going on and make sure it gets saved..

I have read a couple of articles on mixing in GB. They talk about sending the pre mix song/track out of GB and then bringing it in again to start mixing. Like that changes it somehow. What is the story with that?

understood

I have Catalina...I dont know if you actually work for Apple but....do you know is the guitar tuner in GB more accurate now in this updated GB thats in Catalina?I need an accurate free one for intonation setting..

I find the distortion in GB is way too coarse... full of overlpping fx tones and noise... could you give your idea of a good clean overdrive and how to set it up from the fx menus..

I meant the onboard guitar fx distortion..

My interface has a DI and it has a switch. Normally you use it switched in for electric guitar. But if I used a stand alone pre amp or something like a Boss 1000 I would go in a 1/4 inch jack on the back instead because its already line level. I was wondering if I didnt switch the DI in...would it be ok to go in the front with a separate pre or any box that has some kind of signal boost in it.. many devices do.... I know this is a tech question but you probably know what I mean.... I am trying to get a better knowledge of elec. and signal stuff... all part of the recording process....thanks as always for your knowledge..

mine is the SteinbergRT2 with a switch on the left front mic input.

I have had bizarre and bad experiences so far with my keyboard /DAW integration...not all bad but.. I regret buying the Nektar... it has inexplicably changed signal levels,changed instrument qualities, and been skittish ,sometimes requiring a reboot to get it to clear an unwanted audio fx... anyway about mixing... if I just playback a song or part of a song using cycle and while I am listening change the db level for a track...GB will remember that little change but only for that few seconds, and if I save and replace ,GB will save the new version with that small change,yes??

a couple mix things...when mixing I want to mute the other tracks,yes?? Do I need the master track showing for mixing? If I dont want to do anything iTunes...is my bounce my final ending? If so then I need the master reverb on when I bounce,yes??